Assembly and Operating Instructions
Easy To Assemble
Note: When assembling and preparing unit for use, make sure that the
appliance is NOT plugged into the wall outlet.
STEPS:
• Completely lower cradle car locking handle that locks in the motor unit. (fig. 1)
• Remove the motor unit by pulling upward on the motor handle. (fig. 2)
• Remove the water tank by lifting upward on its handle. (fig. 3)
• Fill the water tank with tap water until the water level is between the MIN> and MAX> marking printed on the tank.
Note: To use the vacuum for wet or dry vacuuming, a minimum of 1.8 liters of water should be poured into tank; do not
exceed the maximum level of 3.3 liters marked on the tank.
• The suction tube can be removed making it easier to fill the tank. (fig. 4) Be sure it is replaced before locking the motor unit in place.
• Replace the tank on the cradle car
, position the motor unit in place and raise the handle that locks the motor unit in place until you
hear it click.
• To ready the vacuum for use, insert the inlet nozzle at the end of the flexible hose into the intake outlet and turn clockwise until it
snaps into place. (fig. 5) To remove hose, turn it counter clockwise and pull outward.
• Place telescoping wand at end of hose with suction release valve and push it fully into place.
• Finally, attach the desired accessory to be used in cleaning to the end of telescoping wand.
Operating Procedure:
STEPS:
• Plug appliance into electrical wall socket.
• Press the ON/OFF button to switch the unit on.
• Slide the variable speed control to the desired suction power.
• To adjust the amount of suction needed for each cleaning accessory, simply slide the suction release valve to the open or
closed position or anywhere in between. (fig. 6)
• Adjust the telescoping wand to desired length by pushing in on the locking button, pulling outward to lengthen or pushing
inward to shorten. When you hear it lock into place it is ready to use.
Multi-Purpose Sprayer:
STEPS:
• Remove plastic shield and HEPA filter from exhaust (fig. 7A) and replace with blower adapter. (fig. 7B)
• Remove hose from intake outlet. (fig. 5 )
• Insert the inlet nozzle at the end of the flexible hose into the adapter by pushing in and turning clockwise until it locks into place.
• Fill sprayer jar with water and connect to the other end of hose.
7
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals